Installing The Controller Card - Epson DYO-211/212 (FDD User Manual

Depending on the drive configuration in your computer, you
may need to remove an existing drive or option card before
you install the DYO drive and PCMCIA controller card. For
instructions on how to remove an option card or a drive, see
the manual that came with your computer. Also, as you install
the DYO dual drive, make sure to refer to the option card and
drive installation instructions in your computer manual too, as
the configuration of your computer's option slots and drive
bays may differ somewhat from the illustrations shown in this
Guide.

Installing the Controller Card

Before you install the DYO 211 or 212 PCMCIA controller card,
check the components on the card and the computer's system
board to determine which slot to use. You must use a 16-bit
option slot, which has two connectors for the card. (An 8-bit
slot has only one connector; a 32-bit slot has three.) Make sure
that no components are touching or obstructing other cards or
cables. Also, see your computer manual for special slot
restrictions or considerations.
Refer to the instructions in your computer manual and follow
the steps below to install the 16-bit ISA controller card and the
DYO dual drive:
1. Turn off the power to the computer; then disconnect the
power cord.
2. Follow the instructions in your computer manual to remove
the cover from the computer.
6