Post-Installation Procedures; Installing Card And Socket Services Software; Configuring The Pcmcia Drive For Windows '95 - Epson DYO-211/212 (FDD User Manual

Epson dyo-211/212 (fdd)
Table of Contents

Advertisement

Post-installation Procedures

Restart your computer to check that the DYO dual drive is
correctly installed. You should see its lights turn on
(continuous or flashing yellow). Then run the SETUP program
to verify that the new 3.5-inch diskette drive is configured
properly. See the manual that came with your computer for
instructions on running the SETUP program.
If you are using DOS or Windows, you must also install card
and socket services software to configure your PCMCIA drive
socket(s), as described in the next section. If you are using IBM
OS/2, OS/2 Warp, or Microsoft® Windows NT 3.5, you do not
have to install card and socket services. See the documentation
for your operating system software for instructions on how to
configure your DYO PCMCIA drive. If you are using Microsoft
Windows '95, skip to the "Configuring the PCMCIA Drive for
Windows '95" section.
Installing Card and Socket Services Soft ware
The SystemSoft card and socket services software configures
your PCMCIA socket for use with PCMCIA cards. You must
install this software before you can use PC cards with the DYO
dual drive. See the SystemSoft card and socket services
documentation for instructions on how to install and use
SystemSoft software.

Configuring the PCMCIA Drive for Windows '95

If you are using Microsoft Windows '95 as your computer
operating system, you do not have to load card and socket
services software. If you have installed the DYO dual drive
before installing Windows '95, the software automatically
configures your PCMCIA drive.
13

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dyo-211Dyo-212

Table of Contents