Epson AcuLaser C2900N User Manual page 118

No. n / Mask (n is 1–5.)
No. n / Mode (n is 1–
5.)
IEEE 802.1x
Note:
❏ IEEE 802.1x feature is available only when the printer is connected using LAN cable and it is
available only when the IEEE 802.1 authentication is enabled.
❏ To enable IEEE 802.1x, use "EpsonNet Config" on page 35. For details, refer to the Help on the
Software Disc.
Purpose:
To disable IEEE 802.1x authentication. The change becomes effective after the printer is turned off
and then on again.
Value:
Disable
Initialize NVM
Purpose:
To initialize wired network data stored in non-volatile memory (NVM). After executing this function
and rebooting the printer, all wired network settings are reset to their default values.
Adobe Protocol
Purpose:
To set the PostScript communications protocol.
Values:
Auto*
Standard
BCP
Sets the address mask for Filter n.
Disables the IP Filter feature for Filter n.
Off*
Accepts an access from the specified IP address.
Accept
Reject Rejects an access from the specified IP address.
Disables IEEE 802.1x.
Sets the PostScript communications protocol automatically.
Sets the PostScript communications protocol to Standard.
Sets the PostScript communications protocol to BCP.
Epson AcuLaser C2900 Series
Using the Operator Panel Menus
User's Guide
118