Epson AcuLaser C2900N User Manual page 116

IPv4 Get IP Address
IP Address
Subnet Mask
Gateway Address
IPsec Disable*
Note:
To enable IPsec, use "EpsonNet Config" on page 35. For details, refer to the Help on the Software Disc.
Protocol
Purpose:
To enable or disable each protocol. The change becomes effective after the printer is turned off and
then on again.
Values:
LPD
Sets the IP address automatically. A random value in the range of
DHCP /
Autonet* 169.254.1.0 to 169.254.254.255 that is not currently in use on the
network is set as the IP address. The subnet mask is set as 255.255.0.0.
BOOTP Sets the IP address using BOOTP.
RARP Sets the IP address using RARP.
DHCP Sets the IP address using DHCP.
Panel Use this option when you want to set the IP address manually on the
operator panel.
When an IP address is being set manually, the IP is allocated to the
printer using the format nnn.nnn.nnn.nnn. Each octet that makes up
nnn.nnn.nnn.nnn is a value in the range of 0 to 254. 127 and any value in
the range of 224 to 254 cannot be specified for the first octet of a
gateway address.
When an IP address is being set manually, the subnet mask is specified
using the format nnn.nnn.nnn.nnn. Each octet that makes up
nnn.nnn.nnn.nnn is a value in the range of 0 to 255. 255.255.255.255
cannot be specified as the subnet mask.
When an IP address is being set manually, the gateway address is
specified using the format nnn.nnn.nnn.nnn. Each octet that makes up
nnn.nnn.nnn.nnn is a value in the range of 0 to 254. 127 and any value in
the range of 224 to 254 cannot be specified for the first octet of a
gateway address.
Disables IPsec.
Disable Disables the Line Printer Daemon (LPD) port.
Enable* Enables the LPD port.
Epson AcuLaser C2900 Series
Using the Operator Panel Menus
User's Guide
116