Table of Contents
Advertisement
5.3.6
Rebuilding the RAID
This option is only for the RAID 1 set.
Rebuilding the RAID with other non-RAID disk
If any of the SATA hard disk drives included in the RAID 1 array failed, the system displays
the status of the RAID volume as "Degraded" during POST. You can rebuild the RAID array
with other installed non-RAID disks.
To rebuild the RAID with other non-RAID disk:
1.
At the prompt, press <Ctrl> + <I> to enter the Intel Rapid Storage Technology option
ROM utility.
2.
If there is a non-RAID SATA Hard Disk available, the utility will prompt to rebuild the
RAID. Press <Enter>, and then use up/down arrow keys to select the destination disk
or press <ESC> to exit.
"Degraded" volume and disk available for rebuilding detected. Selecting
a disk initiates a rebuild. Rebuild completes in the operating system.
Select a destination disk with the same size as the original hard disk.
5-30
[
DEGRADED VOLUME DETECTED
Select the port of destination disk for rebuilding (ESC to exit):
Port Drive Model
X
XXXXXXXXXXX
[ ↑↓ ]-Previous/Next [ENTER]-Select [ESC]-Exit
Serial #
Size
XXXXXXXX
XX.XGB
]
Chapter 5: RAID configuration
Advertisement
Table of Contents
