6.
Push the tray lever until it clicks, and
secures the drive tray in place. The drive
tray is correctly placed when its front
edge aligns with the bay edge.
7.
Repeat steps 1 to 6 if you wish to install
a second SATA drive.
2.7.4
Removing and reinstalling the backplane
DO NOT remove the backplane unless necessary!
1.
Remove all hot-swap HDD trays from the
chassis.
2.
Disconnect all cables from the SATA
backplane.
3.
Loosen the four screws on the
backplane.
4.
Firmly hold the backplane, lift it up and
remove it from the module.
5.
Follow the previous instructions in
reverse to reinstall the backplane.
2-18
Chapter 2: Hardware setup