Electrical Installation - Asko T793 Operating Instructions Manual

Installation instructions
To connect the exhaust duct to a
ventilation outlet, follow the steps below:
1. Connect the exhaust duct to a ventilation
exhaust fitting or to a discharge through
the wall.
2. Secure the duct joint to the outlet stub on
the machine.
3. Run the duct with as few bends as possible
to the point of discharge.
Ventilation grill
Warning!
This appliance shall not be exhausted into a
chimney, a wall, a ceiling, an attic, a crawl
space or a concealed space of a building.
Only a rigid or flexible metal duct shall be
used for exhausting. Only a metal ventilation
grill shall be used. If the duct is taken to a wall
outlet, a ventilation grill shall be fitted to pre-
vent reverse flow of cold air. Fit the ventilation
grill to the outside or inside of the wall.
If there is only one vent
duct from the room, a
vent spacer must be fitted.
Vent spacer
30
Make sure nothing is
blocking the ventill
Customer Care Center
www.askousa.com

Electrical installation

Warning!
The receptacle on the rear of the machine is
designed to accommodate ASKO washers
ONLY (rated 208–240 V.) To use this recep-
tacle, you must use the ready-fitted plug
supplied with the washing machine or an
equivalent.
ASKO washers rated 208–240 V have two
internal fuses of 15 A each.
The machine should only be connected to a
grounded wall socket.
Warning!
This appliance must be properly grounded.
Refer to the "Important Safety Instructions"
for grounding instructions.
The power supply cord must be grounded. If
the machine is to be used in a wet area, the
supply must be protected by a residual current
device.
Connection to a permanently wired supply
point must be made only by a qualified electri-
cian. As supplied: Single-phase, 230 V, 60
Hz, 3000W heater rating 30 A circuit required
1-800-898-1879
Remove cover to access terminal
box. (Requires a 20-Torx screw-
driver.)