Asko T793 Operating Instructions Manual page 32

Installation instructions
8. Replace terminal box cover on back of
dryer.
9. Plug dryer into wall receptacle.
10. Turn power on at breaker/fuse box.
Connecting a 4-wire Power Cord
Warning!
Before starting this procedure, be sure the
power is turned off at the breaker/fuse box.
Power Supply Cord
You will need a 4-wire power supply cord with
four No. 10 copper wires and a matching 4-
wire receptacle of NEMA Type 14-30R, as il-
lustrated below.
The fourth wire must be identified with a white
cover and the ground conductor by a green
cover.
To connect a 4-wire power cord to the dryer,
follow the steps below.
Note
The numbers in the illustration below correlate
to the step numbers.
1. Turn the power off at the breaker/fuse box.
2. Remove terminal block cover.
3. Use the strain relief attached below the
terminal block opening.
4. Remove center terminal block screw.
6
32
5. Remove ground wire (green with yellow
6. Connect ground (green) wire of cord to
7. Connect neutral (white) wire of cord under
8. Connect the other wires to outer screws.
9. Tighten the strain relief screws.
10. Replace terminal box cover on back of
11. Plug dryer into wall receptacle.
12. Turn power on at breaker/fuse box.
4
7
8
Customer Care Center
1-800-898-1879
www.askousa.com
stripes) from external ground connector
screw and remove from center terminal
block.
external ground conductor screw.
center screw of terminal block.
dryer.