Adjusting The Feet; Air Exhaust - Asko T793 Operating Instructions Manual

Installation instructions

Adjusting the feet

Screw the feet in or out so that the tumble
dryer is steady and balanced on the floor or
on the washing machine. Then tighten the
lock nuts.
Lock nut

Air exhaust

Connecting the exhaust duct to the dryer
Note
You will need to purchase a UL-CSA-ap-
proved 4-inch ridged metal exhaust duct. The
dryer is delivered with the stub pipeattached
to the rear exhaust outlet, but the exhaust
duct can be attached to either the right or left
exhaust outlet.
Asko dryers have a
"T-stile" exhaust vent that
allows you to connect the
duct on the rear or on the
left or right side
.
Side Exhaust Outlet
The duct must not be assembled with screws
or other fastening that extend into the duct
and catch lint.
28
Vent
T-tube
Rear Exhaust Outlet
Stub Duct
Clamp
(not supplied)
Customer Care Center
www.askousa.com
To connect the exhaust duct to the rear
outlet
To connect the exhaust duct to the rear outlet,
follow the steps below:.
1. Push the duct onto the stub pipe and se-
cure it with a clamp
2. With the duct attached, insert the stub pipe
into the hole. It should snap into place.
3. After you push the dryer into place, check
for kinks in the duct.
Note
Excessive duct length and too many bends
can impede drying performance. We recom-
mend that you cut off any excess exhaust duct
and run the duct with as few bends as possi-
ble. Make any necessary bends as gentle as
possible.
Note
Maximum duct length of 60 feet and 4 elbows
is allowed. Subtract 4 feet of duct for each
90° elbow.
1-800-898-1879