Mounting The Adjustable Brackets In The Rack - HP 316095-B21 - StorageWorks Edge Switch 2/24 Installation Instructions Manual

Fw 05.01.00 and sw 07.01.00 edge switch 2/24 rack mount kit installation instructions
Hide thumbs Also See for 316095-B21 - StorageWorks Edge Switch 2/24:
Table of Contents

Advertisement

Rack Mount Instructions

Mounting the Adjustable Brackets in the Rack

Use these steps to install the adjustable brackets on the rack. You will need a #2
Phillips screwdriver and eight 10x32 panhead screws to complete this procedure.
Note:
series rack, you will need eight square alignment washers to complete this procedure.
1. Determine the position of the switch in the rack. Each Edge Switch 2/24 is
2. Attach four bar nuts (three-hole bar nuts) to the cabinet frame using eight (8)
Note:
3. Measure cabinet depth from inside edge to inside edge of the cabinet frame.
4. Assemble two sets of front and rear brackets so that the combined brackets are
5. Attach a two-hole bar nut using four (4) Phillips flathead screws (8-32 x 7/16)
6. Install the assembled brackets in the cabinet by sliding the mounting brackets
7. Tighten the three-hole bar nut screws on the mounting brackets to where the
8. Securely tighten the two-hole bar nut screws holding the front and rear
18
If you are installing the Edge Switch 2/24 in an HP 9000, 10000 or 11000
1.75 inches or 1U high.
Phillips panhead screws (10-32 x 1/2) with split lock and flat washers.
Do not install a screw in the center hole of each bar nut.
a. If you are installing the Edge Switch 2/24 in an HP 9000, 10000 and
11000 series rack, place a square alignment washer on each panhead
screw before inserting in the square cabinet frame holes.
b. Mount the bar nut on the inside of the cabinet frame. Orient the holes in
the bar nut so that they are aligned closest to the inside edge of the cabinet
frame.
c. Secure, but do not completely tighten all screws.
equal to the depth of the cabinet.
to hold each assembled bracket together. Do not completely tighten but
tighten enough to hold the brackets together.
between the bar nut and cabinet frame.
rails are stable, but can be easily adjusted.
brackets together.
Edge Switch 2/24 Rack Mount Kit Installation Instructions

Advertisement

Table of Contents
loading

Table of Contents