Installing The Switch; Mounting The Switch In A 19-Inch Rack By Using Mounting Brackets - HP 1920 Series Getting Started Manual

Installing the switch

WARNING!
Before installing or moving the switch, remove the power cord.
You can install an HP 1920 switch in a 19-inch rack, on a workbench, or on a wall.
Mounting the switch in a 19-inch rack by using
mounting brackets
1. Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2. Verify that the rack is securely grounded and is stable.
3. Select mounting brackets for the switch.
The HP 1920-8G switch uses Type-A mounting brackets, as shown in
The HP 1920-8G-PoE+ (65W) and 1920-8G-PoE+ (180W) switches use Type-B mounting
brackets, as shown in
The HP 1920- 1 6G, 1920-24G, 1920-24G-PoE+ (180W), 1920-24G-PoE+ (370W), 1920-48G,
and 1920-48G-PoE+ (370W) switches use Type-C mounting brackets, as shown in
4. Attach the mounting brackets to both sides of the chassis with screws.
NOTE:
Mounting brackets are used only for securing the switch to the rack. A rack shelf on the rack is used
to bear the switch weight.
Figure 1 Attaching Type-A mounting brackets to the switch
Figure 2 Attaching Type-B mounting brackets to the switch
Figure 2.
4
Figure 1.
Figure 3.