Long Term Storage Of Your Heater; Maintenance - Dyna-Glo RMC-KFA45T, RMC-KFA65T, RMC-KFA120T, RMC-KFA170T, RMC-KFA210T User Manual

NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
TO STOP HEATER
1. Turn switch to "OFF" and unplug power cord.
TO RESTART HEATER
1.Wait 10 seconds after stopping heater.
2. Repeat steps under to start heater.

8. LONG TERM STORAGE OF YOUR HEATER

1. Drain fuel tank through fuel cap opening.
2. Using a small amount of kerosene, swirl and rinse the inside of the tank.
NEVER mix water with the kerosene as it will cause rust inside the tank. Pour the kerosene out
making sure that you remove it all.
IMPORTANT: Do not store kerosene over summer months for use during next heating season.
- Reinstall fuel cap. Properly dispose of old and dirty fuel.
- Store heater in dry well ventilated area. Make sure storage place is free of dust and corrosive fumes.
- Store the heater in the original box with the original packing material and keep the USER'S
MANUAL with the heater.

9. MAINTENANCE

WARNING!!: NEVER SERVICE HEATER WHILE IT IS PLUGGED IN
OR WHILE HOT!
USE ORIGINAL EQUIPMENT REPLACEMENT PARTS. Use of third party
or other alternate components will void warranty and may cause unsafe
operating conditions.
A.) FUEL TANK
FLUSH EVERY 200 HOURS OF OPERATION OR AS NEEDED (SEE STORAGE ABOVE)
B.) AIR INTAKE FILTER
WASH AND DRY WITH SOAP
AND WATER EVERY 500 HOURS
OF OPERATION OR AS NEEDED.
- Remove screws along each side
of heater using medium phillips
screwdriver
- Lift upper shell off.
- Remove fan guard.
- Wash or replace air intake filter.
- Reinstall fan guard and upper shell.
Using old fuel could damage heater.
9
Upper Shell
Air Intake Filter
Fan Guard
Figure 10