Table of Contents
Advertisement
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
Lamp
Thermostat
Power/Reset
Switch
Control Knob
(KFA80DGDR MODEL ONLY)
KFA50DGDR/80DGDR Models KFA135DGDR/180DGDR/220DGDR Models
NOTICE : The major electrical components of this heater are protected by a safety fuse mounted to the PCB board.
If your heater fails to start, check this fuse first and replace as necessary. You should also check your
power source to insure that proper voltage and frequency are being supplied to the heater.
TO STOP HEATER
1. Turn switch to "OFF" and unplug power cord.
TO RESTART HEATER
1.Wait 10 seconds after stopping heater.
2. Repeat steps under to start heater.
PIGGYBACK POWER CORD
WARNING : SHOCK HAZARD!
• Always cover electric outlet when not in use.
• Don't plug and use an appliance more than 120V/60Hz 5A
current in this outlet.
8. LONG TERM STORAGE OF YOUR HEATER
FUEL TANK DRAIN
1. Drain fuel tank through fuel cap opening.
(For KFA50DGDR/80DGDR Models Only)
2. Remove fuel drain bolt from rear bottom side of fuel tank using 3/4" socket or adjustable wrench and drain.
(For KFA135DGDR/180DGDR/220DGDR Models Only. See Figure 10)
3. Using a small amount of kerosene, swirl and rinse the inside of the tank.
NEVER mix water with the kerosene as it will cause rust inside the tank.
Pour the kerosene out making sure that you remove it all.
IMPORTANT : Do not store kerosene over summer months for use during next heating season.
4. Reinstall fuel cap. Properly dispose of old and dirty fuel.
(For KFA50DGDR/80DGDR Models Only)
5. Reinstall fuel drain bolt to Fuel tank and tighten firmly using 3/4" socket
or adjustable wrench.(For KFA135DGDR/180DGDR/220DGDR Models Only.
See Figure 10)
IMPORTANT : Before reinstalling the fuel drain bolt, make sure the
6. Store heater in dry well ventilated area. Make sure storage place is free
of dust and corrosive fumes.
7. Store the heater in the original box with the original packing material and keep the USER'S MANUAL
with the heater.
Room Temp. Display
Lamp
Thermostat
Power/Reset
Control Knob
Switch
Figure 8. Controls for All Models
Using old fuel could damage heater.
seal is on the bolt. If the seal is not used the bolt cannot
be installed correctly and the fuel tank will leak.
Btu Control Switch
Btu Control Switch
Fan Guard
KFA80DGDR/135DGDR/180DGDR/220DGDR Models only
Figure 9. Piggy Back Power Cord
9
Push to"HIGH"
Push to"LOW"
Cover
Outlet
Fuel Drain Bolt
Figure 10. Fuel Drain Bolt
Relief Valve
Seal
Advertisement
Table of Contents
