Kenmore 1441 - 18 in. Portable Dishwasher Use And Care Manual page 12

Care and Cleaning
continued
]
Property Damage Hazard
Freezing temperatures may cause water
lines to rupture. Be sure all supply lines to
and circulating lines within dishwasher are
)rotected.
Failure to do so could result in property
damage.
Cleaning the Filter
For optimum performance, your dishwasher is
equipped with a filter assembly featuring a main
filter, cup and fine filter as shown in the drawing
above. All food fragments are removed from the
dishwasher as water passes through the filter
assembly.
Each part of the assembly should be cleaned often
to ensure that all food fragments are removed from
the dishes. To remove food fragments from the
filter assembly, the filters must be removed from
the dishwasher. To remove the filters, pull up on
the edge of the main filter. Next, rinse the main
filter and fine filter under running water. Cleaning
with a brush may also be necessary to remove
any fragments trapped in the filters. Once
cleaning has been completed, simply reassemble
the filter as shown in the drawing above. To
ensure that the filter is fully seated, please press
down on the top of the main filter. Using the
dishwasher without a properly installed filter is
not recommended as it will reduce the
cleaning efficiency and may damage dishware.
Cleaning the Spray Arm
The spray arm may need to be cleaned to insure
that there are no clogs to the spray arm jets and
bearings due to hard water chemicals.
To remove spray arm simply hold the spray arm in
place and turn the retaining nut clockwise and
pull up on the spray arm lifting off the shaft.
To clean the spray arm use warm soapy water
using a soft brush to clean the jets and bearings.
To replace the spray arm simply set the spray arm
on the shaft, take the retaining nut and turn it
counter clockwise till it has locked into place.
12