Kenmore 1317 - Pro 24 in. Dishwasher Use And Care Manual page 18

To install double rear insert
NOTE: It will be easier to install the inserts if you remove the silverware basket from the rack.
1.
Place the double rear insert end legs under the 3rd
wire from the right as shown below.
IMPORTANT: Make sure that the curved wires, on the
bottom of the insert, fit over the wires in the bottom of
the rack.
2. Push down on insert until handle fits against outer rack
edge.
3. When center tab under handle locks in under the
middle side rack wire, the insert is in place. (See
illustration.)
To install single front insert
1. Place the single front insert end legs under the 2nd
wire from the right as shown below.
IMPORTANT: Make sure the 3 hooks at the back of
the insert are installed over the 2nd bottom rack wire
from the front of the rack.
2. Push down on insert until handle fits against outer rack
edge.
3. When center tab under handle locks in under the
middle side rack wire, the insert is in place. (See
illustration.)
B
A, 3 insert hooks
B. Single front insert end legs
Utensil caddy
Use the utensil caddy to hold specialty cooking utensils
(serving spoons, spatulas, and similar items), or overflow
silverware items.
The caddy hangs on the bottom rack in the right-hand
corner. Load the caddy while it is on the bottom rack or
remove the basket for loading on a counter or table.
NOTE: Spin the spray arms. Be sure items in the caddy
do not stop the rotation of the spray arms.
18