Start Method (Mac Version) - HitachiSoft FXTRIO-88W User Manual

StarBoard FX-TRIO Series
If the positions of the pen tip and cursor are out of alignment, select "MENU" on the StarBoard
Software toolbar → "Settings" → "StarBoard"→ "Calibrate," and then perform position
alignment.
Important
Conduct sensor adjustments upon first-time operations and whenever
the board has been moved.
Not doing so may cause operation errors.

2.3.2 Start Method (Mac version)

(1) Connect the devices with reference to the connection method on page 1-16.
(2) Turn on the power switch of the projector.
(3) Turn on the power switch of the PC to start Mac
(4) Adjust the position of the projector so that the Mac screen projected by the projector is
within the input area (refer to page 1-5 of this User's Guide).
(5) Select "Go" → "Applications" → "StarBoard Software" to start StarBoard Software.
(6) Select "MENU" on the StarBoard Software toolbar → "Settings" → "StarBoard" →
"Check Connection," and then check the connection.
If the "StarBoard is not connected" message appears, StarBoard Software has not detected
the StarBoard. Check whether the StarBoard and PC are connected properly.
If they are connected properly, the "StarBoard is connected" message appears. If the
indication does not change even though you have checked the connection, there is likely to
be some problem. For details, see "3. Appendix Troubleshooting " on page 3-1 in this user's
guide.
(7) Start "Go" → "Applications" → "Lsadrv" → "LsCamWiz," and then adjust the sensor in
accordance with the procedure on page 3-6
Connected
2-8
No Connection
How to use
English