How To Use; How To Use Touch Mode; Character Input - HitachiSoft FXTRIO-88W User Manual

StarBoard FX-TRIO Series

2. How to Use

2.1 How to Use Touch Mode

This section gives a basic description of how to use the board in touch mode.

2.1.1 Character Input

To input characters, use your finger or the stylus that was provided with the product.
NOTICE
Use an input tool with a thickness of least 7 mm.
When inputting to this product, use a tool that is at least 7 mm. If a pen or similar tool
with a thickness of less than 7 mm is used, the input will be unstable.
Also, do not use tools with a sharp tip, such as a ballpoint pen. If such a tool is used
incorrectly, it could damage the surface of the board.
- Using the stylus pen and Electronic pen
Use the pen on the board with your body kept sufficiently away, so that your palm and
elbow do not touch the board. If your hand or elbow touches the board, or you are within 1
cm of the board, it might cause an incorrect operation.
2-1
How to use
English