Wall-Mounting Setup Method - HitachiSoft FXTRIO-88W User Manual

StarBoard FX-TRIO Series

1.4.1 Wall-Mounting Setup Method

WARNINGS
Keep the wall material in mind when installing.
Installing the board on to the wall in a way that does not suite the wall material, may
result in the board falling off the wall causing injuries or damage to the board.
Furthermore, wall installation may not be possible depending on the wall. For details,
consult with your dealer.
Keep the wall strength in mind when installing.
Only use this product after confirming that it is securely attached and will not fall.
Furthermore, be sure to install using a wall-mounting bracket capable of supporting a
weight of at least 50 kg when using FX-TRIO-77 and supporting a weight of at least 70
kg when using FX-TRIO-88W.
[1] Install the wall-mounting brackets
Determine the height at which the board will be installed, and install the wall-mounting
brackets on the wall at the positions shown in the following diagram below.
The wall-mounting brackets are provided with the StarBoard. ((4) on page 1-2)
Wall-mount stabilizing sponge
It is installed only in FX-TRIO-88W.
1108±2mm
1-8
Introduction
FX-TRIO-77 : 287mm
FX-TRIO-88W : 310mm
English