Removing the hard disk drive tray
To remove the hard disk drive tray, complete the following steps.
Note: The following illustration shows how to remove the hard disk drive tray from
the blade server; removing the hard disk drive tray from the MPE unit is similar.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. If the blade server is installed in a BladeCenter unit, remove it (see "Removing
3. Remove the blade server cover (see "Removing the blade server cover" on
4. If you are removing the drive tray from the blade server and an MPE unit is
5. Remove the hard disk drive from the drive tray, if one is installed (see
6. Remove the four screws that secure the drive tray to the system board; then, lift
7. If you are instructed to return the drive tray, follow all packaging instructions,
88
BladeCenter LS21 Type 7971 and LS41 Type 7972: Problem Determination and Service Guide
on page 63.
the blade server from a BladeCenter unit" on page 65).
page 68).
installed, remove the MPE unit (see "Removing an expansion unit" on page 70).
"Removing a SAS hard disk drive" on page 74).
the drive tray out of the blade server.
and use any packaging materials for shipping that are supplied to you.