Hs20 Type 8832 Sol Jumper Placement; Updating The Integrated Systems Management Processor Firmware; Updating And Configuring The Blade Server Bios - IBM HS40 - BladeCenter - 8839 Setup Manual

HS20 Type 8832 SOL jumper placement

For SOL operation with the HS20 Type 8832 blade server, jumper J28 on the blade
server must be installed on pins 2 and 3. This is the default jumper position that
directs SOL data to I/O-module bay 1 in the BladeCenter unit.
Updating the integrated systems management processor
firmware
Note: Make sure that the blade server BIOS is upgraded and configured before
you update the integrated systems management processor firmware (see
"Updating and configuring the blade server BIOS" on page 13).
Complete the following procedure to update the BladeCenter HS20 Type 8832 or
Type 8843 blade server integrated systems management processor (ISMP)
firmware. No configuration is required for the BladeCenter HS20 Type 8832 or
Type 8843 blade server ISMP to enable SOL.
Attention:
button on the front of the blade server or through the BladeCenter
management-module Web interface while the ISMP firmware update is in progress.
This will interrupt the update procedure and might damage the blade server.
Complete the following steps to update the BladeCenter HS20 Type 8832 or Type
8843 blade server ISMP firmware:
1. Download the latest version of ISMP firmware for your blade server type from
2. Update the blade server ISMP firmware, following the instructions that come
28
BladeCenter: Serial over LAN Setup Guide
2 - 3
I/O-module
bay 1
Do not change the BladeCenter media tray owner by pressing the
http://www.ibm.com/support/.
with the update file that you downloaded. To update the blade server ISMP
firmware click Blade Tasks → Firmware Update in the BladeCenter
management-module Web interface or use an update diskette.
I/O-module bay
SOL select
(J28)
3 3 1 - 2
I/O-module
2 2
bay 2
1
1