IBM HS40 - BladeCenter - 8839 Setup Manual page 26

2. Add the following line after the tty6 line at the bottom of the /etc/securetty
3. Complete the following steps to modify the /boot/grub/menu.lst file:
Note: The entry beginning with kernel (hd0,1) is shown with a line break after
vga=791. In your file, the entire entry must all be on one line.
The following samples show the original content of the /boot/grub/menu.lst file
and the content of this file after modification.
Original /boot/grub/menu.lst contents
gfxmanu (hd0,1)/boot/message
color white/blue black/light-gray
default 0
timeout 8
title linux
kernel (hd0,1)/boot/vmlinuz root=/dev/hda2 acpi=oldboot vga=791
initrd (hd0,1)/boot/initrd
title floppy
root
chainloader +1
title failsafe
kernal (hd0,1)/boot/vmlinuz.shipped root=/dev/hda2 ide=nodma apm=off vga=normal nosmp
disableapic maxcpus=0 3
initrd (hd0,1)/boot/initrd.shipped
Note 1: The entry beginning with kernel (hd0,1) is shown with a line break after nosmp. In your file, the entire
entry must all be on one line.
20
BladeCenter: Serial over LAN Setup Guide
file to enable a user to log in as the root user through the SOL console:
ttyS1
a. Comment out the gfxmenu... line by adding a # at the beginning of the
line.
b. Add the following line before the first title... line:
# This will allow you to only Monitor the OS boot via SOL
c. Add the following text to the end of the first title... line:
SOL Monitor
d. Add the following text to the end of the kernel... line of the first title...
section:
console=ttyS1,19200 console=tty1
e. Add the following lines between the first two title... sections:
# This will allow you to Interact with the OS boot via SOL
title linux SOL Interactive
kernel (hd0,1)/boot/vmlinuz root=/dev/hda2 acpi=oldboot vga=791
console=tty1 console=ttyS1,19200
initrd (hd0,1)/boot/initrd
Notes
1