10. If you have other devices to install or remove, do so now; otherwise, go to
Removing a horizontal-compact-form-factor expansion card
Use these instructions to remove a compact-form-factor expansion card from the
blade server.
The following illustration shows how to remove a horizontal-compact-form-factor
(CFFh) expansion card.
To remove a CFFh expansion card, complete the following steps:
1. Before you begin, read "Safety" on page v and "Installation guidelines" on
2. If the blade server is installed in a BladeCenter unit, remove it (see "Removing
3. Carefully lay the blade server on a flat, static-protective surface.
4. Open the blade server cover (see "Removing the blade server cover" on page
5. Locate the CFFh expansion card. The CFFh is installed into the blade expansion
6. Use your fingers to hold the edge of the CFFh expansion card where it
7. Pull the card away from the expansion-card standoff.
46
BladeCenter HS22 Type 7870, 1936, and 1911: Installation and User's Guide
Note: For device-driver and configuration information to complete the
installation of the expansion card, see the documentation that comes with the
expansion card.
"Completing the installation" on page 54.
page 21.
the blade server from the BladeCenter unit" on page 23 for instructions).
24 for instructions).
connector (see "Blade server connectors" on page 19).
connects to the blade expansion connector; then, lift up on the card.