Using The Lsi Logic Configuration Utility Program; Using Lan Over Usb To Interface The Imm - IBM HS22 - BladeCenter - 7870 Installation And User Manual

User guide
Hide thumbs Also See for HS22 - BladeCenter - 7870:
Table of Contents

Advertisement

Important: You must create the RAID array before you install the operating system
on the blade server.
You can use the LSI Logic Configuration Utility program to configure the storage
drives and the SAS controller. To start the LSI Logic Configuration Utility, see

"Using the LSI Logic Configuration Utility program."

Using the LSI Logic Configuration Utility program
Use these instructions to start the LSI Logic Configuration Utility program.
You can use the LSI Logic Configuration Utility program to perform the following
tasks:
v Set the SAS device scan order
v Set the SAS ID for the controller
v Manage the SAS RAID configuration
To start the LSI Logic Configuration Utility program, complete the following steps:
Note: The LSI controller on your blade server is a UEFI compatible device and can
also be configured through the Setup utility for your blade server (see
"Configuring UEFI compatible devices" on page 66).
1. Turn on the blade server, and make sure that the blade server is the owner of
2. When the <<<Press Ctrl-C to start LSI Logic Configuration Utility>>>
3. Use the arrow keys to select the controller from the list of adapters; then, press
4. Follow the instructions on the screen to change the settings of the selected

Using LAN over USB to interface the IMM

The IMM does not require IPMI device drivers or USB daemons for in-band IMM
communication. Instead, a LAN over USB interface enables in-band
communications to the IMM; the IMM hardware on the system board presents an
internal Ethernet NIC from the IMM to the operating system. LAN over USB is
also called the "USB in-band interface" in the IMM Web interface.
Typically, the IMM IP address for the LAN over USB interface is set to a static
address of 169.254.95.118 with a subnet mask of 255.255.0.0. In the event of an IP
address collision on the network, the IMM might obtain a different IP address in
the 169.254.xxx.xxx range.
Because the IMM might obtain a different IP address for the LAN over USB
interface, the IBM Advanced Settings Utility (ASU) and firmware flash utilities,
DSA, and the IBM Director Agent use the Service Location Protocol (SLP) to
discover the IMM IP address. These tools perform an SLP multicast discovery on
the LAN over USB interface. When they receive a response from the IMM, they
obtain the attributes that contain the IP address the IMM is using for the LAN over
USB interface.
68
BladeCenter HS22 Type 7870, 1936, and 1911: Installation and User's Guide
the keyboard, video, and mouse.
prompt is displayed, press Ctrl+C.
Enter.
items; then, press Enter. If you select SAS Topology or Advanced Adapter
Properties, additional screens are displayed.

Advertisement

Table of Contents
loading

Table of Contents