Table of Contents
Advertisement
Monitor Driver Installation
Driver installation for Windows 95 or Windows 98
This section must be
completed before
continuing with the
Windows95 or Windows98
Auto Setup on page 9.
i
On LCD monitors, unlike
CRTs, a faster refresh rate
does not improve display
quality. IBM recommends
using either 1024 x 768 at a
refresh rate of 60Hz or 640 x
480 at a refresh rate of 60Hz.
To use the Plug and Play feature in Microsoft®Windows®95 or Windows
98, files should be loaded from the IBM Monitor CD.
1. Turn off the computer and all attached devices.
2. Ensure that the monitor is connected correctly.
3. Turn on the monitor and then the system unit. Allow the system to boot
into Windows95 or Windows98.
Your computer's Plug and Play code may warn you that your system
hardware has changed. This means that it has detected your new
monitor for the first time.
4. Open the
DISPLAY PROPERTIES
and then double - clicking on the
CONTROL PANEL
5. Click the
tab.
SETTINGS
• In case of Windows 95 :
6 -
Click the
1.
CHANGE DISPLAY TYPE
. Click the
2
CHANGE MONITOR TYPE
• In case of Windows 98 :
6 -
. Click the
1
ADVANCED
. Click the
tab.
2
MONITOR
Open the
3.
UPGRADE DEVICE DRIVER WIZARD
button and then select the
CHANGE
Click the "Display a list of the known drivers for this device so that
4.
I can choose a specific driver" and then select the
7. Insert the Setup CD into the CD driver: and click the
8. Click OK.
9.
Ensure that the CD drive letter is selected, and then select the 'Drivers'
folder.
10.Choose IBM T541 monitor and Click OK. The files will be copied from
the CD to your hard disk drive.
11.Close all open windows and remove the CD.
12.Restart the system.
The system will automatically select the maximum refresh rate and
corresponding Color Matching Profiles.
window by clicking
button.
button.
button.
window by clicking on
button.
NEXT
,
,
START
SETTINGS
icon.
DISPLAY
button.
NEXT
button.
HAVE DISK
5
Hide quick links:
Advertisement
Table of Contents
