Device Driver Installation; Windows 95/98 - IBM THINKVISION MONITOR L150 User Manual

Device Driver Installation

Driver installation for Windows 95 or Windows 98
This section must be
completed before
continuing with the
Windows 95 or Windows 98
Auto Setup
on page 15
On LCD monitors, unlike
CRTs, a faster refresh rate
does not improve display quality.
IBM recommends using either
1024 x 768 at a refresh rate of
60Hz or 640 x 480 at a refresh
rate of 60Hz.
10
To use the Plug and Play feature in Microsoft
files should be loaded from the IBM Monitor CD.
1. Turn off the computer and all attached devices.
2. Ensure that the monitor is connected correctly.
3. Turn on the monitor and then the system unit. Allow the system to boot
into Windows 95 or Windows 98.
Your computer's Plug and Play code may warn you that your system
hardware has changed. This means that it has detected your new
monitor for the first time.
4. Open the
DISPLAY PROPERTIES
CONTROL PANEL
5. Click the
SETTINGS
• In case of Windows 95 :
6. 1. Click the
CHANGE DISPLAY TYPE
2. Click the
CHANGE MONITOR TYPE
• In case of Windows 98 :
6. 1. Click the
ADVANCED
2. Click the
MONITOR
3. Open the
UPGRADE DEVICE DRIVER WIZARD
on button and then select the NEXT button.
CHANGE
4. Click the "Display a list of the known drivers for this device so that
I can choose a specific driver" and then select the NEXT button.
7. Insert the Setup CD into the CD driver: and click the
8. Click OK.
9. Ensure that the CD drive letter is selected, and then select 'Drivers'
folder.
10. Choose IBM ThinkVision L150/150p monitor and Click OK. The
files will be copied from the CD to your hard disk drive.
11. Close all open windows and remove the CD.
12. Restart the system.
The system will automatically select the maximum refresh rate and
corresponding Color Matching Profiles.
window by clicking
and then double - clicking on the
tab.
button.
button.
button.
tab.
® ®
Windows 95 or Windows 98,
START, SETTINGS,
icon.
DISPLAY
window by clicking
HAVE DISK
button.