Manually Adjusting The Image Settings - IBM 9512AB1 - T 541 - 15" LCD Monitor User Manual

Manually adjusting the image settings

i
If the monitor is in standby
mode (STANDBY ON), it
might automatically turn off
while you are waiting for it to
warm up.
Normally, you can complete the setup procedure using Image S
if your screen image is still distorted after you perform Image S
CD does not run on your system, perform M
1. Have your monitor turned on for about 15 minutes, until the monitor
warms up.
2. Display the image you most frequently use on the screen.
3. Press the OSD Enter button
the initial OSD menu.
4. Use an Arrow button (
and press the OSD Enter button
5. Using an Arrow button (
press once to select COARSE. Left and right arrow adjustment
indicators become illuminated (see page 16).
6. Use the Arrow buttons to manually adjust to correct (as much as
possible) for jitter or noise in the image, then press
changes.
7. Use an Arrow button to select FINE and press the
8. Use the Arrow buttons again to tune the image to your liking.
9. When finished, press the Exit button
OSD.
You have completed the monitor setup.
S
ANUAL ETUP
at the botton of the monitor to display
or ) to select the IMAGE SET-UP icon
to access the function.
or ), select MANUAL, press
four times to exit from the
, however,
etup
or the setup
etup
.
and then
to save the
button.
11