° At this point, remove the Decorative
Bolt on bottom
of
refrigerator
housing from the left side of refrJgeraton
you will
need this hole for the Bottom Hinge.
J
Fig. 23
° Move the Bottom Hinge to the left side of housing, keeping
the same oreintation,
and reattach
with 3 bolts. Now move
Decorative
Bolt to hole on lower right side of housing.
Fig. 24
° Turn refrigerator
door upside down on a non-scratching
surface.
° With
door upside down, loosen the 2 screws and remove the
Door Closer/Stop,
the loosen the other two screws to remove
the Bottom Hinge Pin Insert Bracket with Hinge Pin Insert.
NOTE: The Refrigerator
Door Closer/Stop
is not used on all
models. The model you have may not include
this part.
"Fig.25
?
Door C loser/Stop
Fig. 26
Hinge
Pin
Hinge Pin
insert
° Take out the Hinge Pin insert and move the Bracket to the
other side of the door, keeping the same orientation.
° Place Hinge Pin insert into the left side of the bracket.
Tighten
Hinge Pin Bracket to door.
Hinge
Pin Bracket
Hinge Pin Insert
° Take Door Closer/Stop
and flip. Line up screw holes and
mount on left side of door bottom
with the two screws. Turn
door upright.
It is now ready for re-attaching.
NOTE: The Refrigerator
Door Closer/Stop
is not used on all
models. The model you have may note include this :art.
_Fig. 28
_
° With
flat-head
screwdriver,
carefully
pry off and remove
the cover over the screw holes on the left side of refrigerator
housing.
Fig. 29
14