Ensuring Proper Air Circulation; Freezer Control - Kenmore 7937 - 22.1 cu. Ft. Top Freezer Refrigerator Use And Care Manual

ENSURING PROPER AiR CiRCULATiON
in order to ensure proper temperatures, air must flow
between the refrigerator and freezer sections. As shown in
the illustration below, air enters at the top of the freezer and
circulates down. From bottom of the freezer, air is forced up
to top of the refrigerator. Air enters to the refrigerator through
top vent, then circulates and exists at the bottom, where it
returns to the freezer.
Do not block any of the cool air vents with food packages.
If the vents are blocked, airflow will be restricted and
temperature and moisture problems may occur.
iMPORTANT: Because air circulates between both sections,
Any odors formed in one section wiii transfer to the other.
You must thoroughly clean both sections to eliminate odors. To
prevent odor transfer and drying out of food, wrap or cover
foods tightly. (See the Food Storage Guide section for details).
NOTE: If you close the refrigerator door
forcefully, the freezer door may open and
close again due to pressure from internal
air flow.
SETTING THE CONTROLS
Your refrigerator has two controls that let you regulate the
temperature in the freezer and refrigerator compartments.
REFRIGERATOR CONTROL
Initially set the
Refrigerator
Control on the middle
setting,
number 3. To do so, push the temperature adjust button until
the number 3 LED light is lit up. Leave the refrigerator at this
setting for 24 hours to reach correct temperature.
After 24 hours, adjust the compartment temperature as
desired. The higher the number, the colder the refrigerator
compartment wili become. Always wait 24 hours before
adjusting temperature. If you go past the desired number,
keep pushing the temperature adjust button until your desired
number is lit up.
NOTE: When you disconnect the device or a power failure
occur it wiii initialize in the last temperature level before the
disconnect or failure ocurred.
.......................... RECOMMENSE5 .....
........ _ I COLD I COLDEST I __._
fO_ IC23 C3CDC23C3C3 I tO\ "\
:_WATER ICOoOFL_ NG 1 3 5 I FILTE R :
_\ LOCK I /TEMP_ I CNANGE/
_'-_ I _ I _-__---'_
* Water Lock: Press the "WATER LOCI<" button to lock the
dispenser (button light ON).
When it is locked, the dispenser wiil not operate. To unlock,
press the "WATER LOCI<" button (button light OFF).
Filter Change: When the filter Change light turns on, you
have to change the water filter. Press and hold the "FILTER
CHANGE" button for 3 seconds to turn the light off:. You need
to change the water filter approximately every 6 months.
FREEZER CONTROL
The freezer control should come
from the factory set on the middle
setting, number 2.
Wait 24 hours before adjusting
the temperature of the freezer
compartment up or down. Turn the
dial to set freezer temperature as
desired.
ALWAYS wait 24 hours after any
adjustment for unit to reach desired
temperature.
FREEZER
TEMPERATURE
0 C01d
RECOMMENDE£
D Colder
NEXT
1. Clean your refrigerator thoroughly and wipe off: all dust
accumulated during shipping.
2. Install accessories such as ice cube bin, drawers, shelves, etc.,
in their proper places. They are packed together to prevent
possible damage during shipment.
17