Prepare The Water System; Refrigerator Use; Ensuring Proper Air Circulation; Using The Controls - Kenmore 106.5133 Series Use & Care Manual

Complete the Installation
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1. Plug into a grounded 3 prong outlet.
2. Flush the water system. See the "Prepare the Water System" or
"Water and Ice Dispensers" sections.
NOTE:

PREPARE THE WATER SYSTEM

Please read before using the water system.
Immediately after installation, follow the steps below to make sure
that the water system is properly cleaned.
1.
Maker and Storage Bin" section.
NOTE:
properly installed. See the "Water Filtration System" section.
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
2. Flush the water system. Use a sturdy container to depress and
hold the water dispenser lever for 5 seconds, and then release
5
5 5
11
As air is cleared from the system, water may spurt out of the
dispenser.
3. Open the freezer door and turn on the ice maker. See the
"Ice Maker and Storage Bin" section.
12
be required in some households.

REFRIGERATOR USE

ENSURING PROPER AIR CIRCULATION

In order to ensure proper temperatures, you need to permit air to
freezer section and moves up. It then enters the refrigerator section
through the top vent. Air then returns to the freezer as shown.
will be obstructed and temperature and moisture problems may
occur.
IMPORTANT: Because air circulates between both sections, any
odors formed in one section will transfer to the other. You must
thoroughly clean both sections to eliminate odors. To avoid odor
transfer and drying out of food, wrap or cover foods tightly.

USING THE CONTROLS

The refrigerator and freezer controls are located on the dispenser
panel.
IMPORTANT: The display screen on the dispenser control panel
control buttons and dispenser pad have not been used for
control button will only reactivate the display screen, without
changing any settings.
Touch any control button on the dispenser panel to activate the
display screen. The home screen will appear as shown.