Kenmore 7937 - 22.1 cu. Ft. Top Freezer Refrigerator Use And Care Manual page 30

The door is not closing properly. See "Door will not close completely" in troubleshooting guide.
Frost or ice
crystals on The door is opened often. When the door is opened, warm, humid air is allowed in the
frozen food freezer resulting in frost.
The icemaker was recently installed. Discard first few batches of ice to avoid discolored or off-
flavored ice.
The ice has been stored for too long. Throw away old ice and make a new supply.
The food had not been wrapped tightly in Rewrap foods since odors may migrate to the ice if food is
_ce has off- either compartment, not wrapped properly.
taste or odor The water supply contains minerals such as A filter may need to be insatiled to eliminate taste and odor
sulfur, problems.
The interior of refrigerator needs cleaning. See Care and aeanlng section.
Ice storage bin needs cleaning. Empty and wash bin. Discard old cubes.
The refrigerator is defrosting. The water will evaporate. It is normal for water to drip into
the defrost pan.
It is more humid than normal. Expect that the water in the defrost pan will take longer to
evaporate. This is normal when it is hot or humid.
There is
water in the
defrost drain
pan
The
refrigerator
seems to
make too
much noise
The sounds may be normal for your
refrigerator.
Refer to the Understanding Sound You May Hear section.
New installation. Wait 24 hours after icemaker installation for ice production
to begin. Wait 72 hours for full ice production.
The refrigerator is not connected to a water Connect refrigerator to the water supply and turn water
supply or the supply shutoff valve is not turned shutoff valve fully open.
on.
Reverse osmosis water filtration system is Reverse osmosis filtration systems can reduce the water
connected to your cold water supply, pressure below the minimum amount and result in icemaker
issues.
I<ink in the water
source line.
A kink in the
line can
reduce water flow. Straighten the water
source line.
A large amount of ice recently has been Allow 24 hours for the icemaker to produce more ice.
removed. NOTE: An extra ice bucket is provided in the freezer section.
The icemaker is not turned on. Locate the icemaker on/off switch and confirm it is in the ON
(1)position.
The icemaker
is not There is something on the ice-detecting sensor. Foreign substances or frost on the ice-detecting sensor can
producing ice interrupt ice production. Make sure the sensor area is clean at
or not enough all times for proper operation.
ice The temperature setting for the freezer is too Below O°F is the recommended temperature for the freezer
warm. compartment for normal ice production. If the freezer
temperature is warmer, ice production will be affected.
The doors are opened often.
If the doors of the unit are opened often, the cold air will
escape which will prevent the unit from maintaining the set
temperature. Lowering the temperature can help, as well as
not opening the doors as frequently.
The doors are not closing properly. If the doors are not properly closed, ice production will be
affected.
The ice compartment door is not dosing If the ice compartment door is not properly dosed, ice
properly, production will be affected. Make sure ice compartment door
is dosed for proper operation.
3]