Unpacking Your Refrigerator; Explosion Hazard; Base Grille Installation - Kenmore 7937 - 22.1 cu. Ft. Top Freezer Refrigerator Use And Care Manual

EXCESSIVE WEIGHT HAZARD
Use two or more people to move and install refrigerator.
Failure to do so can result in back or other injury.
UNPACKING YOUR REFRIGERATOR
Remove tape and any temporary labels from your refrigerator
before using. Do not remove any warning type labels, the
model and serial number label, or the techsheet (on some
models), that is attached to back wall of the refrigerator.
To remove any remaining tape or glue, rub the area briskly
with your thumb. Tape or glue residue can also be easily
removed by rubbing a small amount of liquid dish soap over
the adhesive with your fingers. Wipe with warm water and dry.
Do not use sharp instruments, rubbing alcohol, flammable fluids
or abrasive cleaners to remove tape or glue. These products
can damage the surface of your refrigerator. For more
information, see the Important Safety Instructions section.
Refrigerator shelves are installed in the shipping position.
Please reinstall shelves according to your individual storage
needs.
When Moving Your Refrigerator:
Your refrigerator is heavy. When moving the refrigerator for
cleaning or service, be sure to protect the floor. Always pull
the refrigerator straight out when moving it. Do not wiggle
or walk the refrigerator when trying to move it, as floor
damage could occur.
EXPLOSION HAZARD
Keep flammable materials and vapors, such as gasoline,
away from refrigerator.
Failure to do so can result in death, explosion or fire.
INSTALLATION
1. Avoid placing the unit near heat sources, direct sunlighh or
moisture.
2. To minimize noise and vibration, the refrigerator MUST be
installed on a solidly constructed floor.
3. Carpeting and soft tile surfaces are not recommended.
4. NEVER install the refrigerator on a platform or a weakly
supported structure.
5. Install this appliance in an area where the temperature is
between 55°F (13°C) and ]10°F (43°C.) If the temperature
around the appliance is too low or high, cooling ability
may be adversely affected.
NOTE: For proper air circulation, best cooling and energy
consumption results, maintain a minimun distance of 2 inches
(5.08 cm) form adjacent items and surfaces.
m
_2" ( 5.08ore)-_
2" (5.08 cm) 2" (5.08 cm)
NEXT
1. Clean your refrigerator thoroughly and wipe off all dust
accumulated during shipping.
2. install accessories such as ice cube bin, drawers, shelves, etc.,
in their proper places. They are packed together to prevent
possible damage during shipment.
3. Let your refrigerator run for 2 or 3 hours before store food in
it. Check the flow of cold air in the freezer compartment to
ensure proper cooling. Your refrigerator is now ready for use.
• Be careful when you work with hinge, base grille, stopper
etc. You may be iniured.
• Do not put hands or metal sticks into air vents, base grille
or bottom of refrigerator. You may be iniured or receive
an electrical shock.
BASE GRILLE INSTALLATION
To install or replace base grllle:
• Refrigerator door should be opened or removed.
(Necessary on some models).
• Use the 2 Phillips screws provided in the literature package to
attach the Base Grille.
To remove the base grille
• Open or remove refrigerator doors.
(Necessary on some models).
• Take out the base grille by removing the 2 screws on the
bottom of the refrigerator.
9