Connecting The Brother Machine To The Wireless Network - Brother HL-4570CDW Quick Setup Manual

For Wireless Network Users

Connecting the Brother machine to the wireless network

Configure the wireless
9
settings using the
automatic wireless mode
a
Confirm your WLAN access point/router has
the Wi-Fi Protected Setup or AOSS™ symbol
as shown below.
b
Place the Brother machine within range of your
Wi-Fi Protected Setup or AOSS™ access
point/router. The range may differ depending
on your environment. Refer to the instructions
provided with your access point/router.
c
On your machine, press + or - to choose
Network and press OK.
Press + or - to choose WLAN and press OK.
Press + or - to choose WPS/AOSS and press
OK.
When WLAN Enable? is displayed, press + to
accept. This will start the wireless setup wizard.
Otherwise press Cancel to exit from the
wireless setup wizard.
When Press Key on rtr appears, press
the Wi-Fi Protected Setup or AOSS™ button
on your WLAN access point/router. See the
user's guide for your WLAN access point/router
for instructions. And then press +.
This feature will automatically detect which
mode (Wi-Fi Protected Setup or AOSS™) your
access point/router uses to configure your
machine.
Note
If your WLAN access point/router supports Wi-Fi
Protected Setup (PIN Method) and you want to
configure your machine using the PIN (Personal
Identification Number) Method, see Using the PIN
Method of Wi-Fi Protected Setup in the Network
User's Guide.
d
A connection result message appears on the
LCD and a WLAN report will automatically be
printed.
If the connection failed, check the error code on
the printed report and refer to
Troubleshooting on page 20.
18
Wireless setup is now complete. A four
level indicator at the right of your
machine's LCD will show the wireless
signal strength of your access
point/router.
To install the printer driver, continue to
step 10.
®
For Windows Users:
Now go to
page 23
For Macintosh Users:
Now go to
page 24