Lexmark 920dn - C Color LED Printer Manual page 18

Menu selection Purpose
Standby Mode Specifies the amount of time (in minutes)
the printer stays in Standby Mode before
it goes into a power save.
Alarms Controls whether the printer sounds an
alarm when the printer requires operator
intervention.
Timeouts Specifies the amount of time (in
seconds) the printer waits to return to the
home screen, receive an end-of-job
message, or receive additional bytes of
data from the computer.
Note: Wait Timeout is only available
when you use PostScript emulation. This
menu value has no effect on PCL
emulation print jobs.
Values
1...to the current
Power Saver value
Alarm Control:
Off
Single*
Continuous
Toner Alarm:
Off*
Single
Continuous
Staple Alarm:
Off*
Single
Continuous
Hole Punch Alarm:
Off*
Single
Continuous
Screen Timeout:
15–300
(30*)
Print Timeout
Disabled
1–255
(90*)
Wait Timeout:
Disabled
15...65535 (40*)
Using printer menus
18
The default setting is 15 minutes and can be
adjusted in 1 minute increments.
Off—Printer does not sound an alarm.
Single*—Printer sounds three quick beeps.
Continuous—Printer repeats three beeps
every 10 seconds.
Note: Staple and hole punch alarms
appear only when an optional finisher is
installed.
Disabled—Disables Screen Timeout.
15–300—Specifies the amount of time the
printer waits before returning to the home
screen.
30* is the default setting.
Disabled—Disables Print Timeout.
1–25—Specifies the amount of time the
printer waits for an end-of-job message
before canceling the remainder of the print
job.
Note: When the timer expires, any partially
formatted page still in the printer is printed,
and other input ports are examined to see if
data exists.
90* is the default setting.
Disabled—Disables Wait Timeout.
15...65535—Specifies the amount of time
the printer waits for additional data before it
cancels the job.
40* is the default setting.