Lexmark 920dn - C Color LED Printer Manual page 14

Custom Types
Menu selection Purpose
Custom Type N Specifies the type of paper associated
with each Custom Type available in the
Paper Type menu.
Universal Setup
Menu selection Purpose
Units of Measure Determines the unit of measure used to
enter the Universal Height and Width.
Portrait Width Sets the portrait width of the universal
media.
Note: If the value set exceeds the
maximum width, the printer will use the
maximum value allowed in inches or
millimeters.
Portrait Height Sets the portrait height of the universal
media.
Note: If the value set exceeds the
maximum height, the printer will use the
maximum value allowed in inches or
millimeters.
Feed Direction Specifies the feed direction of the
Universal Paper Size.
Bin Setup
Note:
Bin Setup is only displayed when
at least one optional output bin is
installed.
Menu selection Purpose
Output Bin Specifies the default bin for printed
material.
This menu selection is used to define a name for each custom paper type. You can
assign names using a utility such as MarkVision or from the operator panel.
Values
Paper*
Card Stock
Transparency
Glossy
Labels
Vinyl Labels
Envelope
This menu selection is used to specify the height and width of the Universal Paper Size.
By specifying the height and width for Universal Paper Size, the printer will use the
Universal setting exactly like other paper sizes, including support for duplex and n-up.
Values
Inches
Millimeters
3 inches to 48 inches in
0.01 inch increments
76 mm to 1220 mm in 1
mm increments
3 inches to 48 inches in
0.01 inch increments
76 mm to 1220 in 1 mm
increments
Short Edge*
Long Edge
This menu selection is used to specify the output bin where you want your printed
material to go to.
Values
Standard Bin*
Bin <x>
Using printer menus
14
The custom type media must be supported
in the input source you designate in order to
assign a user-defined name.
Once the name is assigned, the name
(truncated to 16 characters) will be
displayed instead of Custom Type x.
Inches is US default; Millimeters is
international default.
Shows either inches or mm from Units of
Measure setting; 14 inches is the US
default, and 365 mm is the international
default.
Shows either inches or mm from Units of
Measure setting; 14 inches US default,
356 international default.
Long Edge is only shown if the longest edge
is shorter than the Maximum Physical Width
of the printer.
• If a user-defined name is available, it is
displayed instead of Bin <x>.
• The name is truncated to 14 characters.
• If two or more bins share the same name,
the name only appears once in the
Output Bin value list.