Pump Mounting/Plumbing; Electrical - Hayward PowerFlo Matrix Owner's Manual

™
Power-Flo Matrix
Installation Instructions (cont.)
Pump Location (cont.)
Install pump on a firm, level base or pad to meet all local and national codes. The field supplied base or pad must be
level and vibration-free.
Though the pump is designed for outdoor use, it is strongly advised to protect the electrical components from the
weather. Select a well-drained area, one that will not flood when it rains. Pump motors require free circulation of air
for cooling. Do not install pump in a damp or non-ventilated location.
Pump Mounting
Fasten pump to base or pad with screws or bolts to further reduce vibration and stress on pipe or hose joints.
NOTE: Allow adequate access for servicing pump and piping.
Plumbing
To facilitate servicing of pump and to allow for indoor storage during the winter months, installing union connections
at the suction and outlet ports is recommended.
Use Teflon tape to seal threaded connections on molded plastic components. All plastic fittings must be new or
thoroughly cleaned before use. NOTE: Do NOT use Plumber's Pipe Dope as it may cause cracking of the plastic
components.
When applying Teflon tape to plastic threads, wrap the entire threaded portion of the male fitting with one to two
layers of tape. Wind the tape clockwise as you face the open end of the fitting, beginning at the end of the fitting.
The pump suction and outlet ports have molded-in thread stops. Do NOT attempt to force hose connector fitting past
this stop. It is only necessary to tighten fittings enough to prevent leakage. Tighten fitting by hand and then use a tool
to engage fitting an additional 1 ½ turns. Use care when using Teflon tape as friction is reduced considerably; do
NOT over-tighten fitting or you may cause damage. If leaks occur, remove connector, clean off old Teflon tape, re-
wrap with one to two additional layers of Teflon tape, and re-install connector.

Electrical

electrical problem. If GFCI trips and won't reset, consult electrician to inspect and repair electrical
system.
WARNING – Fire Hazard.
Insure that the electrical supply available agrees with the motor's voltage, phase, and cycle, and that the wire size is
adequate for the H.P. (KW) rating and distance from the power source.
NOTE: All electrical wiring MUST be performed by a qualified professional, and MUST conform to local
codes and regulations.
Pump Series
WARNING –
Failure to ground pump motor can cause serious or fatal electrical shock hazard.
WARNING –
WARNING –
motor before working on electrical connections.
WARNING –
Match supply voltage to motor nameplate voltage.
Ground motor before connecting to electrical power supply.
Do NOT ground to a gas supply line.
To avoid dangerous or fatal electrical shock, turn OFF power to
Ground Fault Circuit Interrupter (GFCI) tripping indicates
____________________