Faxing
●
Faxing
●
This section explains the basic procedure for the Fax function.
The Fax function enables you to scan documents and transmit them as faxes or receive faxes via a
telephone line.
Be sure to finish the initial setup before using this function.
Procedure for Fax
3
This section explains how to transmit faxes. The
following procedure uses the direct input method
for specifying a destination.
You need to configure the initial settings before
using the Fax function.
Note
● Up to 40 digits can be entered for the destination fax
number.
Memo
● You can load only A4, letter, or legal size documents in
the ADF, and A4 or letter size documents on the document
glass.
● You cannot load mixed size documents for faxing.
● The following procedure uses the factory default settings.
1
Press the <FAX/HOOK> key on the
operator panel.
2
Place your document in the ADF or on
the document glass as below:
● ADF
Load documents face up with the top edge of the
documents in first.
Adjust the document guides to the width of your
documents.
● Document Glass
Place the document face down and align its top
edge to the upper-left corner of the glass.
Close the document glass cover gently.
Note
● Do not apply an excessive load to the document
glass.
Memo
● The machine prioritizes the ADF when scanning
documents. Be sure not to place documents on the
ADF when you use the document glass.
3
Check that [Fax] is selected and
press
to open the fax start screen.
OK
- 38 -