— Check your power supply —
Make sure that your local AC mains voltage matches the voltage speciﬁed on the name plate on the bottom panel. In some areas a
voltage selector may be provided on the rear panel of the main keyboard unit near the power cord. Make sure that the voltage
selector is set for the voltage in your area. The voltage selector is set at 240V when the unit is initially shipped. To change the setting
use a "minus" screwdriver to rotate the selector dial so that the correct voltage appears next to the pointer on the panel.
For information on assembling the instrument, refer to the instructions at the end of this manual.
C L P - 4 7 0
C L P - 4 4 0
C L P - 4 3 0
C L P - S 4 0 8
C L P - S 4 0 6
C L P - 4 6 5 G P