Power Led Not On; Power Led Never Turns Green; Adsl Led Not On Or Blinking - NETGEAR DM111P - ADSL2+ Ethernet Modem Setup Manual

The ADSL port LED is lit, indicating that your modem router is synchronized to your
c.
ISP's DSLAM.
d. The Internet LED is lit to indicate that you have an Internet connection.
If any of these conditions does not occur, refer to the appropriate following section.

Power LED Not On

If the Power and other LEDs are off when your modem router is turned on:
• Make sure that the power cord is properly connected to your modem router and that the power
supply adapter is properly connected to a functioning power outlet, and the power switch on
the back of the modem router is pressed in.
• Check that you are using the 12 V DC power adapter supplied by NETGEAR for this product.
If the error persists, you have a hardware problem and should contact technical support.

Power LED Never Turns Green

If the Power LED never turns green, the modem router's self-test procedure failed.
• Cycle the power to see if the modem router recovers.
• Clear the modem router's configuration to factory defaults. This will set the modem router's IP
address to 192.168.0.1. This procedure is explained in
If the error persists, you might have a hardware problem and should contact technical support.

ADSL LED not On or Blinking

If the ADSL LED is not lit, no ADSL link is detected. Check the following:
• Make sure that the telephone jack is live—temporarily connect a standard telephone to the
telephone jack to check for a dial tone.
• Make sure that the telephone cable connections are secure at the modem router and at the
ADSL-capable telephone jack.
If the ADSL LED is on, but is continuously blinking, the modem cannot synchronize with your
ISP's equipment.
14
"Using the Reset Button" on page 19.
Troubleshooting