Power Led Is Off Or Never Turns Green - NETGEAR DM111P - ADSL2+ Ethernet Modem User Manual

ADSL2+ Modem Router User Manual
2. After approximately 10 seconds, verify that:
a. The Power LED changes color from red to green.
b. The LAN port LEDs is lit to indicate that the modem router is connected to your PC or
router.
c. The ADSL port LED is lit, indicating that your modem router is synchronized to your
ISP's DSLAM.
d. The Internet LED is lit to indicate that you have an Internet connection.
Note: If the Internet LED is off, it might not mean that you do not have an
If any of these conditions does not occur, refer to the appropriate following section.

Power LED Is Off or Never Turns Green

The following table provides troubleshooting tips for situations when the Power LED is off or
never turns green.
Table 3-1. Power LED Troubleshooting
Power LED Situation
The Power and other LEDS are off
when the modem router is turned
on.
The Power LED never turns green. This indicates that the modem router's self-test failed.
3-2
Internet connection. It means that you do not have an Internet connection
through the PPP. When you connect the Internet using IPoA or bridging,
the Internet LED will not light up.
Action
• Make sure that the power cord is properly connected to your modem
router, that the power supply adapter is properly connected to a func-
tioning power outlet, and the power switch on the back of the modem
router is pressed in.
• Check that you are using the 12 V DC power adapter supplied by
NETGEAR for this product.
• If the error persists, you have a hardware problem and should contact
technical support.
• Cycle the power to see if the modem router recovers.
• Clear the modem router's configuration to factory defaults. This will
set the modem router's IP address to 192.168.0.1. This procedure is
explained in
• If the error persists, you might have a hardware problem and should
contact technical support.
v1.0, October 2008
"Using the Reset button" on page 3-8.
Troubleshooting