Configuring Your Internet Connection; Installation Requirements - NETGEAR DM111P - ADSL2+ Ethernet Modem User Manual

This chapter describes how to configure your ADSL2+ Modem Router DM111P(U)v2 Internet
connection. When you perform the initial configuration of your modem router using the Resource
CD as described in the ADSL2+ Modem Router Setup Manual, these settings are configured
automatically for you. This chapter provides further details about these settings, as well as
instructions on how to log in to the modem router for further configuration.
Note: NETGEAR recommends using the Smart Wizard™ Installation Assistant on the
Resource CD for initial configuration, as described in the ADSL2+ Modem Router
Setup Manual.
This chapter includes:
•

"Installation Requirements"

• "Using the Smart Wizard to Set Up Your Modem Router" on page
• "Logging In to the Modem Router" on page
• "Setting Up Your Modem Router Manually" on page
• "LAN IP Setup" on page
• "How the Internet Connection Works" on page
Installation Requirements
Before installation, please have your DSL log in user name and password available. If not
available, please obtain them from your Internet Service Provider (ISP) at the numbers below and
IMMEDIATELY FOLLOW NETGEAR INSTALLATION PROCEDURES located in the Smart
Wizard installation CD.
• For Earthlink customers, please call 1-800-EARTHLINK.
• For AT&T customers, please call 1-877-722-3755.

Configuring Your Internet Connection

Configuring Your Internet Connection
in the following section.
1-9.
v1.0, October 2008
1-2.
1-4.
1-10.
Chapter 1
1-2.
1-1