Troubleshooting - Maytag MHW9000YG Use And Care Manual

USING THE BUILT-IN TROUBLESHOOTING FEATURE
1.
Press LEARN MORE
With the washer on, press LEARN MORE to access the built-in
troubleshooting feature. Use the LCD control buttons to select

TROUBLESHOOTING.

TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.maytag.com/help
If you experience
Washer Operation
Washer will not run
Water Leaks
Water leaks
Other Issues
Other performance
or operation issues
18
for assistance and to possibly avoid a service call.
Possible Causes
Door not closed completely.
START/PAUSE button not pressed
firmly or held long enough.
Household fuse is blown or circuit
breaker has tripped.
Wrong type of household fuse.
Incorrect power supply.
Fill hoses not attached tightly.
Fill hose washers missing.
Drain hose connection not correct.
Check household plumbing for leaks
or clogged sink or drain.
Door seal is dirty.
Not using HE detergent or using too
much HE detergent.
Dispenser is clogged.
Refer to the built-in troubleshooting
feature on the washer.
2.
Select TROUBLESHOOTING
Then use the LCD control buttons to select the desired
troubleshooting topic. Use the
through the different options.
Make sure the washer door is closed completely.
Press and hold the START/PAUSE button 2-5 seconds.
Check that the household fuse is intact and tight, or that the
circuit breaker has not tripped. Replace the fuse or reset
the circuit breaker. If the problem continues, call a qualified
electrician.
Use a time-delay fuse.
This washer requires a 120-volt power supply.
Check with a qualified electrician.
Tighten fill-hose connections.
Make sure all 4 fill hose washers are installed correctly.
Properly secure drain hose to drainpipe or laundry tub. Refer to
the Installation Instructions for additional information.
Do not place tape over drain opening.
Water can backup out of a clogged sink or drainpipe. Check all
household plumbing for leaks (laundry tubs, drain pipe, water
pipes, and faucets.)
Clean the door seal. See "Washer Maintenance."
Use only HE High Efficiency detergents and follow
the manufacturer's recommendations.
Remove and clean the dispenser. See "Washer Maintenance."
See the instructions above to access the built-in
TROUBLESHOOTING menus using the LEARN MORE button.
and buttons to advance
Solution