Electrical Connections--3-Wire; Electrical Connections--4-Wire - Kenmore 8041 - 5.8 cu. Ft. Capacity Electric Dryer Installation Instructions Manual

ELECTRICAL CONNECTIONS
FOR 3-WIRE SYSTEM
i Non-Canadian ELECTR/CDryer i
1. Remove the screws securing the terminal block accesscover
and the strain relief mounting bracket located on the
back of the dryer upper corner.
2. Install a U.L approved strain relief into the power cord entry
hole of the mounting bracket. Finger tighten the nut only at
this time.
GREEN GROUND SCREW
NEUTRAL
GROUND
WIRE
SILVER TERMINAL
IUT
TIGHTEN NUT TO
THESE THREADS
RELIEF
MOUNTING
BRACKET
POWER CORD
3. Thread a U.L approved 30 amp. power cord, NEMA 10-30
Type SRDT,through the strain relief.
4. Attach the power cord neutral (center wire) conductor to
the silver colored center terminal on the terminal block.
Tighten the screw securely.
5. Attach the remaining two power cord outer conductors to
the outer brass colored terminals on the terminal block.
Tighten both screws securely.
Do not make a sharp bend or crimp wiring/
conductor at connections.
6. Reattach the strain relief mounting bracket to the back of
the dryer with two screws. Tighten screws securely.
7. Tighten the screws securing the cord restraint firmly against
the power cord.
8. Tighten the strain relief nut securely so that the strain relief
does not turn.
9. Reinstall the terminal block cover.
ELECTRICAL CONNECTIONS
FOR 4-WIRE SYSTEM
Non-Canadian ELECTR/CDryer j
1. Remove the screws securing the terminal block access cover
and the strain relief mounting bracket located on the back of
the dryer upper corner.
2. Install a U.L approved strain relief in the entry hole of the
mounting bracket. Finger tighten the nut only at this time.
GREEN GREEN POWERCORD
GROUND_ROUND WIRE SILVER TERMINAL
SCREW _ ,TERMINALBLoCK
NEUTRAL __3qlll_
GRO UN DJJ,_----_
WIRE
TIGHTEN NUT
NUT _HREADS
/
REd _ ///_)
1POWER 1/._
/
CORD
3. Removethe ground wire from the green ground screw located
above the terminal block.
_ TYPICAL 4
CONDUCTOR BLACK
WHITE
TYPICAL 4 _-'_,_
RED 240V
CONDUCTOR "GREEN
30 AMP NEMA 14-30 TYPE SRDT OR
4. Thread a U.L approved 30 amp power cord, NEMA 14-30
type STor SRDTthrough the strain relief.
5. Attach the green power cord ground wire to the cabinet with
the green ground screw.
Attach the white (neutral) power cord conductor from the
power cord and the neutral ground wire from the dryer harness
to the silver-colored center terminal on the terminal block.
Tighten the screw securely.
7. Attach the red and black power cord conductors to the outer
brass-colored terminals on the terminal block.
Do not make a sharp bend or crimp wiring/
conductor at the con nections.
8. Tighten the screws securing the cord restraint firmly against
the power cord.
9. Tighten the strain relief nut securely so the strain relief does
not turn.
10. Reinstall the terminal block access cover.
9