ELECTRICAL CONNECTIONS
FOR 4-WIRE SYSTEM
Non-Canadian ELECTRIC Dryer
1. Remove the screws securing the terminal block access cover
and the strain relief mounting bracket located on the back of
the dryer upper corner.
2. Install a U.L. approved strain relief in the entry hole of the
mounting bracket. Finger tighten the nut only at this time.
GREEN
GREEN POWERCORD
GROUND
GROUND WIRE
SILVER TERMINAL
SCREW
TERMINAL
BLOCK
NEUTRAL
BLACK
GROUND
TIGHTEN NUT
WIRE
TO THESE
WHITE
THREADS
NUT
RED
STRAIN
RELIEF
MOUNTING
BRACKET
POWER
CORD
3. Remove the ground wire from the green ground screw located
above the terminal block.
TYPICAL 4
BLACK
CONDUCTOR
WHITE
RED 240V
TYPICAL 4
CONDUCTOR
GREEN
30 AMP NEMA 14-30 TYPE SRDT OR
30 AMP NEMA 14-30 TYPE SRDT OR
30 AMP NEMA 14-30 TYPE SRDT OR
30 AMP NEMA 14-30 TYPE SRDT OR
30 AMP NEMA 14-30 TYPE SRDT OR
4. Thread a U.L. approved 30 amp power cord, NEMA 14-30
type ST or SRDT through the strain relief.
5. Attach the green power cord ground wire to the cabinet with
the green ground screw.
6. Attach the white (neutral) power cord conductor from the
power cord and the neutral ground wire from the dryer harness
to the silver-colored center terminal on the terminal block.
Tighten the screw securely.
7. Attach the red and black power cord conductors to the outer
brass-colored terminals on the terminal block.
Do not make a sharp bend or crimp wiring/
conductor at the connections.
8. Tighten the screws securing the cord restraint firmly against
the power cord.
9. Tighten the strain relief nut securely so the strain relief does
not turn.
10. Reinstall the terminal block access cover.
Page 9