Electrical Connections--3-Wire; Electrical Connections--4-Wire - Kenmore 41798076700 Installation Instructions Manual

ELECTRICALCONNECTIONS ELECTRICALCONNECTIONS FOR 4- WIRE SYSTEM
FOR 3- WIRE SYSTEM
USA ELECTRICDryer
1. Remove the screws securing the terminal block access
cover and the strain relief mounting bracket located on the
back of the dryer upper corner.
2. Install a U.L approved strain relief into the power cord
entry hole of the mounting bracket. Finger tighten the nut
only at this time.
GREEN
SCREW
NEUTRAL
GROUND
WIRE
SILVER
TERMINAL
USA ELECTR/CDryer
l
1. Remove the screws securing the terminal block access cover
and the strain relief mounting bracket located on the back of
the dryer upper corner.
2. Install a U.L approved strain relief in the entry hole of the
mounting bracket. Finger tighten the nut only at this time.
3. Remove the ground wire from the green ground screw
located above the terminal block.
GREEN POWER CORD
GREEN
SILVERTERMINAL
SCREW TERMINAL
BLOC K
tUTTIGHTEN NUT
TO THESE
_READS
BRACKET POWER CORD
3. Thread a U.L approved 30 amp. power cord, NEMA 10-30
type SRDT,through the strain relief.
4. Attach the power cord neutral (center wire) conductor to
the silver colored center terminal on the terminal block.
Tighten the screw securely.
5. Attach the remaining two power cord outer conductors to
the outer brass colored terminals on the terminal block.
Tighten both screws securely.
Do not make a sharp bend or crimp wiring/
conductor at connections.
6. Reattach the strain relief mounting bracket to the back of
the dryer with two screws. Tighten screws securely.
7. Tighten the screws securing the cord restraint firmly against
the power cord.
8. Tighten the strain relief nut securely so that the strain relief
does not turn.
9. Reinstall the terminal block cover.
TIGHTEN
NUT
GROUND WHITE TO THESE
WIRE NUT -HREADS
STRAIN
RELIEF
BRACKET,.
POWER
CORD
4. Thread a U.L approved 30 amp power cord, NEMA 14-30
type ST or SRDTthrough the strain relief.
.
TYPICAL 4
TYPICAL 4 BLACK
C_WHITE
_,_I_ED
30 AMP NEMA 14-30 TYPE SRDT OR ST _GREEN
Attach the green power cord ground wire to the cabinet with
the green ground screw.
.
Attach the white (neutral) power cord conductor from the
power cord and the neutral ground wire from the dryer harness
to the silver-colored center terminal on the terminal block.
Tighten the screw securely.
7. Attach the red and black power cord conductors to the outer
brass-colored terminals on the terminal block.
.
Do not make a sharp bend or crimp wiring/
conductor at the connections.
Tighten the screws securing the cord restraint firmly against
the power cord.
9. Tighten the strain relief nut securely so the strain relief does
not turn.
10.Reinstall the terminal block access cover.
11 Printed in U.S.A.