Advertisement
Available languages
Available languages
1.Dryer MUST be exhausted outside (outdoors, not beneath the mobile
home) using metal ducting that will not support combustion.
Metal
II
ducting must be 4 inches (10.16 cm)in diameter with no obstructions.
Rigid metal duct is preferred.
2.If dryer is exhausted through the floor and area beneath the mobile
home is enclosed, the exhaust system MUST terminate
outside the
enclosure with the termination
securely fastened to the mobile home
___
structure.
3. Refer to page 4 for other important venting requirements.
4.When installing a gas dryer into a mobile home, a provision must be
made for outside make up air. This provision is to be not less than twice
the area of the dryer exhaust outlet.
5. Installation MUSTconform
to current Manufactured Home Construction
& Safety Standard (which is a Federal Regulation Title 24 CFR-Part 32-
80) or when such standard is not applicable, with American National
Standard for Mobile Homes. In Canada, the CSA Z240 is applicable.
_The
laundry center is designed under ANSI Z 21.5.1for HOME USE only.
iiii
1. Using the four shipping carton corner posts (two on each
3.
side), carefully lay the laundry center on its left side and
4.
remove foam shipping base.
_v_
Excessive weight.
Use two or more
people to move Laundry Center.
2. Using a ratchet with 3/8 inch (0.96 cm) socket, remove the
mechanism shipping bolt and plastic spacer block from the
5.
center of the base.
NOTE: If the laundry
center is to be transported
at a later
date, the tub blocking
pad, shipping
bolt, and plastic
spacer block should
be retained.
.
Return laundry center to an upright position.
Remove:
(a) foam tub blocking pad.
(b) tape from dryer door.
(c) foam dryer support pads.
(d) inlet hoses.
(e) enclosure package.
From the back of the washer, remove the wire shipping
clips
securing the drain hose and power cord (if equipped).
Plastic clamps secure the drain hose to the right side of the
washer backsheet. These clamps form a standpipe to prevent
water syphoning. DO NOTREMOVE THESE CLAMPS.
Carefully move the laundry center to within 4 feet (1.22 m)
of the final location to begin the installation.
PLASTICSPACER
BLOCK_
MECHANIS
SHIPPING
BOLT
CARTON CORNER POSTS
FOAM
SHIPPING ......
PAD
CORD
(IF EQUIPPED)
DRAIN HOSE
7
Advertisement
