Laundry
Center
Dryer
Operating
Instructions
Models
97912/97962
DELICA]"ES
TURN TO START
DRYIHG TEb_PERATL_RE
AIR
40
50
YIIJIIE[)
WRINKLE
RID
DRY
E£_c mnic IIIcAs um <3Qnsi_
PERIq
PIRESS
KNI"}'S
{)IUVi II£]A'
IV D}{J [,/s-IOW !q A!
ALITOMATIO
WRII_QRLE=RID
ON
O}
OFF
Before
Operating
Your Dryer
Readyour
Owner's Guide. It has important safety
and warranty information. It also has many
suggestions for best drying results.
To reduce the risk of fire, electric
shock, or injury to persons, read the IMPORTANT
SAFETYINSTRUCTIONSin your owner's guide before
operating this appliance.
Operating
Steps
Read Drying Procedures in your Owner's Guide.
It explains these operating steps in detail.
1. Prepare items for drying.
2. Check that lint screen is dean and in place.
3, Load the dryer, If desired, add a dryer fabric
softener sheet.
4. Close the dryer door.
Printed in U.S.A.
5. Set Drying Temperature
control
6. Turn cycle selector dockwise
to desired
setting.
7, Start dryer, Turn the Turn to Start control
clockwise to ON. Hold for 1-2 seconds and
release.
8. A signal will sound when the cycle ends.
9. Remove items immediately
and hang or
fold.
10. Clean lint screen after every load.
Temperature
Selection
Always
follow
directions
on fabric
care
labels.
To avoid fire hazard, do not use heat
to dry items containing feathers or down, foam
rubber, plastics, or similarly textured, rubber-like
materials. Use Air Fluff-No Heat cycle only.
Select the temperature setting most suitable for each
load. The REGULAR--HIGH HEA T, PERM PRESS--
MEDIUM HEA T,KNITS--MEDIUM-LO
W HEA Ta nd
DELICATES--LOWHEATtemperature
settings may
be used with any cycle setting.
Cycle Selection
Turn cycle selector clockwise to desired cycle and
setting.
The Automatic and Timed Dry cycles end with a cool
down period. The heat automatically turns off and
the load continues to tumble during the cool down
period. This reduces wrinkling and makes items
easier to handle during unloading.
Drying time varies depending on size and dampness
of load, weight and fabric type. Room temperature
and humidity, type of installation and electrical
voltage or gas pressure can also affect drying time.
P/N 137229400 (0906)