Advertisement
How To Install Mag Unit & Foot Step
Required Tools:
The Mag resistance unit and Foot Step now need to be
installed to the frame.
Attach the Foot Step onto the bracket on the Step-Bar first,
put the Mag unit over the Foot Step, then tighten both
brackets together with the pivot bolt.
!
Overtightening the pivot bolt will cause the
Foot-Step to become inoperable.
Make sure you unscrew (loosen) the pivot
bolt by 1/4 - 1/2 turn once you completely
tightened it.
The Mag unit should be lowered towards the
ground by its own weight at this point.
If the pivot bolt is too loose, the Mag unit
will drop quickly and you may be pinched
between the frame and Mag unit.
Adjust the tightening torque for the best
operation.
If you need to adjust the Mag unit position horizontally
to set the tire in the center of the drive roller, loosen the
backside screws and slide the Mag unit sideward.
After adjusting, tighten both screws firmly.
How To Use Small Wheel Adaptor
If your tires is a 26" and smaller than 1.50" in width,
you will need to use the supplied Z-shaped Small Wheel
Adapter.
(The tire size is clearly indicated on its side wall)
The direction of the Z-adapter is fixed so follow the
arrow printed on the top and make sure it's pointing
toward the front (toward your bike).
If the drive roller cannot reach the tire, make sure the
Z-adapter has been installed correctly.
Use the original cap head bolts for the Mount Base, and
use the supplied hex head bolts for the Mag unit.
1 x 5mm Hex Wrench (supplied)
1 x 10mm Spanner (not supplied)
Mag Resistance Unit
Rear Tire
Z-Adaptor
Hex Head Bolt
Cap Head Bolt
- 3 -
Pivot Bolt
Step-Bar
Foot Step
Advertisement
