Creating A Print Queue Using Bradmin32; Configuring The Brother Print Server (Queue Server Mode In Bindery Emulation Mode) Using Bradmin32 - Brother HL 1270N - B/W Laser Printer Network User's Manual

Creating a Print Queue Using BRAdmin32

Brother's BRAdmin32 utility are Windows-based applications that provide similar
functionality to the Netware PCONSOLE utility (or the NWADMIN utility in Netware 4.1x or
later). To use the BRAdmin32 programs to configure a Brother print server under NetWare,
make sure that you are logged in as SUPERVISOR (NetWare 2.xx or 3.xx) or ADMIN
(NetWare 4.1x or later) and perform the following steps:
Configuring the Brother Print Server (Queue Server Mode in Bindery emulation
mode) using BRAdmin32
1.
2.
3.
Note
You can find the node name and MAC address by printing out the printer configuration page.
Refer to the Quick Setup Guide for information on how to print the configuration page on your
print server.
4.
5.
Note
If necessary change the "Print Server Name", the default Netware print server name will be
BRN_xxxxxx_P1 where xxxxxx is the Ethernet address of the print server. Be careful!
Changing the name may impact the configuration of other protocols because the print server
service names will be altered.
Make sure that you logged in as SUPERVISOR (Netware 2.xx or 3.xx) or ADMIN
(Netware 4.xx or later).
Start BRAdmin32.
One or more print server will appear in the list (the default node names are BRN_xxxxxx,
where "xxxxxx" is the last six digits of the Ethernet address (MAC address)).
Select the print server that you wish to configure and double click it. You will be asked
for a password. The default password is "access".
Select the Netware tab.
6-2