Reloading From A Netware Server - Brother HL 1270N - B/W Laser Printer Network User's Manual

When you type a CTRL-D or EXIT to exit the remote console, the file Firmname.bin will then
be loaded into the print server. The Data LED on the printer front panel will blink during the
load process and will go out when the process is complete.
If the Data LED does not stop blinking after about two minutes, or start to blink periodically,
check to make sure that you correctly entered all parameters and that your network
connections are good. Then power the print server/printer off and then on again, enter the
SET LOAD ENABLE command, and then type EXIT to exit the remote console and retry the
download.

Reloading from a NetWare Server

To download from a NetWare server, first copy the load file e.g. Firmname.bin into the
\login directory on your SYS partition (SYS:\LOGIN). Using the \login directory will
eliminate any potential file security problems.
Connect to the print server remote console using console (BRCONFIG or TELNET) and enter
the following commands in response to Local > prompt.
SET LOAD HOST fileservername
SET LOAD SOFTWARE Firmware.bin
SET LOAD ENABLE
where fileservername is the name of the file server. When you type a CTRL-D to exit the
remote console, the file Firmware.bin will then be loaded into the print server.
If the Data LED does not stop blinking after about two minutes check to make sure that you
correctly entered all parameters and that your network connections are good. Then power the
print server/printer off and then on again, enter the SET LOAD ENABLE command, and then
type EXIT to exit the remote console and retry the download.
A-17