Appendix; Command Summary; General Commands - Brother HL 1270N - B/W Laser Printer Network User's Manual

APPENDIX

Appendix A

Command Summary

General Commands

You can change the configuration of your print server using any of the following methods.
Brother BRAdmin32 utility for Windows 95/98 and NT 4.0
HTTP (using a web browser)
TELNET (command utility)
Brother BRCONFIG NetWare Utility (command utility)
BRAdmin32
HTTP
TELNET
The Brother BRAdmin32 utility can use the TCP/IP or IPX/SPX protocol.
This utility allows you to graphically manage aspects of the network and
printer. It runs on Windows 95/98 and Windows NT 4.0
Use your favorite web browser to connect to the Brother print server. This
will allow you to configure print server parameters. You must ensure that the
print server has a valid IP address. Once you have done this type
http://ip_address/ in your web browser. If you can not connect to
the print server check your web browser is configured correctly (check your
proxy settings to ensure that your web browser can connect to the printer on
your internal network). When ever you wish to change a print server
parameter you will be asked for a password. The default password is "access"
To connect to the print server using TELNET on UNIX, Windows NT, or
most other TCP/IP systems, type: TELNET ipaddress at the command
prompt of the system prompt, where ipaddress is the IP address of the print
server. When you are connected, push RETURN or ENTER to get the "#"
prompt, enter the password "access" (the password will not appear on the
screen), and type anything in response to the Enter Username> prompt.
When you see the Local> prompt, you are ready to enter commands.
A-1